View source for Updating from 2.x to 3.x Firmware
From berofix - professional SIP gateway
=Update Procedure= '''Important, please read before updating!''' <span style="color:#ff2345">'''IF YOU USE A FIRMWARE LOWER THAN VERSION 2.3sp3 IT'S STRONGLY RECOMMENDED TO UPDATE TO FIRMWARE VERSION 2.3sp3 FIRST.</span> '''IMPORTANT NOTE: DON'T install the 3.0 Firmware in the recovery Mode of the hardware factory reset when you come from a 2.x Version!!! ''' '''Please note the gateways use DHCP per default in V3!''' Since substantial changes have been made between the 2.3 Firmware and the new 3.0 Firmware, the update process needs a little more attention than usual. To perform a successful update and to keep your current configuration intact, it is strongly recommended to perform the following steps: * First of all update to [http://www.beronet.com/downloads/berofix/appfs-2.3-sp3.tar.gz 2.3sp3] version * Backup your gateway configuration (Management->Backup and Restore) * Reboot the gateway * Update to the new 3.0 Firmware (Management->Firmware Update) * Perfom a factory reset (Management->Reboot/Reset) * Restore your gateway configuration (Management->Backup and Restore) '''The gateway may not be in a fully functioning state until the factory reset has been performed.''' The current stable 3.0 firmware can be downloaded here: [http://www.beronet.com/wp-content/uploads/downloads/berofix/appfs-3.0.10.tar.gz 3.0.10]. The changelog can be viewed here: http://wiki.beronet.com/index.php/Releasenotes#3.0_STABLE_-_Firmware
Updating from 2.x to 3.x Firmware
Retrieved from "
What links here
About berofix - professional SIP gateway