Howto Hardware Factory Reset
From berofix - professional SIP gateway
| Line 3: | Line 3: | ||
*1. Power off the card/device. | *1. Power off the card/device. | ||
*2. In case of a card remove the card from your computer. In case of a Box check if you can access the PCM connector on the rear from the outside, otherwise open the box. | *2. In case of a card remove the card from your computer. In case of a Box check if you can access the PCM connector on the rear from the outside, otherwise open the box. | ||
| − | *3. Short the two | + | *3. '''Card''':Short the two pins horizontal with a jumper ( the yellow marked rectangle see Picture below). '''Box''': Short the two pins vertically with a jumper (the yellow marked rectangle see Picture below) |
| − | [[Image:Bf_HWReset1.png]] | + | |
| + | {| | ||
| + | |[[Image:Bf_HWReset1.png]] | ||
| + | |[[Image:PCM_Hardware.png]] | ||
| + | |- | ||
| + | |} | ||
| + | |||
| + | |||
*4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device. | *4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device. | ||
*5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. Open your Browser with this new address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below). | *5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. Open your Browser with this new address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below). | ||
